Table of Contents
Advertisement
Table 58. Drive bay labels of NVMe solid-state drives
Drive bay 4-7 label of NVMe solid-state drives
1
Install a 2.5-inch hot-swap drive
Use this procedure to install a 2.5-inch drive.
Following are the types of drives supported by this server:
• NVMe solid-state drive
• SATA/SAS solid-state drive
• SATA/SAS hard-disk drive
For a complete list of supported optional device for this server, see
serverproven/index.shtml
Before installing a 2.5-inch hot-swap drive:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install a 2.5-inch drive, complete the following steps:
Step 1.
Determine the available drive bays based on the drive bay labels applied. The following NVMe
labels indicate that these drive bays support both NVMe and SATA/SAS drives. Otherwise, only
SATA/SAS drives are supported.
Figure 54. Drive bay labels of NVMe solid-state drives
Table 59. Drive bay labels of NVMe solid-state drives
Drive bay 4-7 label of NVMe solid-state drives
1
Notes:
1. Make sure to install every drive into the drive bay that supports the type of the specific drive.
Drive type information is available on the drive.
2. When there are both SATA/SAS and NVMe drives to install, first install NVMe drives in reverse
numeral order based on the bay number, and then install the SATA/SAS ones in numeral order.
Step 2.
Remove the drive bay filler if it has been installed in the drive bay.
Step 3.
Gently rotate the release latch away to unlock the drive handle.
Step 4.
Slide the drive into the drive bay, and push it until it stops.
ThinkSystem SR850P Setup Guide
82
.
46).
Drive bay 12-15 label of NVMe solid-state drives
2
https://static.lenovo.com/us/en/
"Safety" on page iii
and
Drive bay 12-15 label of NVMe solid-state drives
2
"Installation
Advertisement
Table of Contents
