Carrier Board Jumpers & Headers - Vecow ESOM-MT-500 User Manual

2.4 Carrier Board Jumpers & Headers
2.4.1 Main Board Jumpers and Headers Location
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists of
two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To "close" a jumper, you connect the pins with the clip.
To "open" a jumper, you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2, and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
J7
J5
J15
J1
©Vecow ESOM-MT-500 User Manual GETTING TO KNOW YOUR ESOM-MT-500 30