Stihl FSA 135 R Instruction Manual page 13

8 Assembling the Trimmer
► Push the deflector (1) into the guides on the
gear housing up to the limit stop.
► Insert the screws (2) and tighten them firmly.
8.3.2 Removing the Deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Unscrew the screws (2).
► Pull off the deflector (1).
8.4 Fitting and Removing the Skirt
8.4.1 Fitting the Skirt
► Switch off the brushcutter and remove the bat‐
tery.
1
2
► Slide the guide slot in the skirt (2) onto the uni‐
versal deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
8.4.2 Removing the Skirt
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin (2) into the hole in the skirt
(1).
► Remove the skirt (1) with the stop pin (2).
0458-662-0121-C
1
3
4
2
1
The line limiting blade (1) can be left on the skirt.
8.5 Mounting and Removing the
Mowing Head
8.5.1 Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
8.5.2 Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove the stop pin.
8.6 Removing and Installing Metal
Cutting Attachment
8.6.1 Mounting the Metal Cutting Attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
English
1
2
3
4
4
1
13