Specifications - Stihl FSA 135 R Instruction Manual

21 Specifications

Fault LEDs on the
battery
The brushcutter 3 LEDs light
cuts out during up red.
operation.
The runtime of
the brushcutter is
too short.
The power levels
cannot be set.
STIHL connected
app is unable to
find the battery
with .
20.2 Product Support and Assis‐
tance on Use
Product support and assistance on use are avail‐
able from STIHL servicing dealers.
For contacts and other information, please visit
https://support.stihl.com or www.stihl.com.
21 Specifications
21.1 STIHL FSA 135 R Brushcutters
– Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without battery, cutting tool and deflec‐
tor: 4.6 kg
– Length without cutting tool: 1885 mm
– Degree of electrical protection: IPX4 (protec‐
tion against splash water from any direction)
For runtime, see www.stihl.com/battery-life.
21.2 STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
0458-662-0121-C
Cause
The brushcutter or
battery is damp.
Trigger is pressed
before operating the
release slide.
Trimmer is too hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
The trigger is
depressed and the
brushcutter switched
on.
®
Bluetooth radio inter‐
face on the battery or
mobile device is deac‐
tivated.
Distance between bat‐
tery and mobile
device is too long.
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: + 10 °C to + 50 °C
– Bluetooth
with
– Data connection: Bluetooth
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
– Mobile appliance operating system require‐
Remedy
► Allow the brushcutter or battery to dry.
► Switch on the brushcutter as described in
this User Manual.
► Remove the battery.
► Allow trimmer to cool down.
► Remove battery and reinsert it.
► Switch on the brushcutter.
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Replace battery.
► Release the trigger and hold only the trig‐
ger lockout pressed.
► Select the power level as described in
this User Manual.
► Activate Bluetooth
battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer for assistance.
®
radio interface (only for batteries
):
mobile appliance must be compatible with
®
Bluetooth Low Energy 5.0 and support
Generic Access Profile (GAP).
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
ments: Android or iOS (current version or
higher)
English
®
radio interface on the
21.2.
®
5.1. The
21