Operation; Reverse Function - Rexel 2020300X Instruction Manual

GB

1. operation

1 Unpack the product.
2 Connect the shredder to mains supply.
3 Ensure the ON/OFF button on the back of the machine is in the ON position, which will
illuminate the blue standby symbol (
4 To commence shredding, press the Auto button (
You are now ready to shred.
5 To load the shredder, simply lift the loading door handle to open the loading door and insert
documents. You can open the door further to 90 degrees for easier access if required Load up
to 300 sheets at a time into the feed chamber. Do not fill above the 300 MAX level, this could
damage the shredder.
6 The shredder will start the shredding cycle automatically ONLY after closing the loading door.
If there is still paper in the Autofeed chamber after first attempt, open and re-close the paper
loading door a second time.
Attention: If required you can now lock the loading door by entering a 4 digit code (see Locking
the Paper Loading Door section).
7 If you only have up to 8 sheets to shred, you can use the manual feed slot, provided the auto
feed chamber is empty.
8 Insert paper to be shredded into the feed area. The shredder will detect the paper and start
automatically.
9 If the shredder is left in auto mode for more than 2 minutes without being used, the shredder will
automatically turn back to sleep mode in order to save power.
10 The shredder will automatically 'wake up' from sleep mode when paper is inserted into the
shred mouth or you open the loading door. There is no need to press the Auto button (

2. reverse function

1 Should you wish to reverse paper out whilst shredding, a reverse button (
your convenience.
2 Reverse the paper out then turn the machine off using the ON/OFF switch at the rear of the
shredder. Remove the paper from the manual feed slot (if being used) or open the loading door,
remove the remaining stack of paper, then pull the jammed paper free of the cutting mechanism.
3 To resume shredding, turn the shredder on using the ON/OFF switch at the rear of the shredder.
Return the switch to the auto position (
10
register this product online at www.accobrands.com
).
), which sets the shredder into auto mode.
).
).
) has been fitted for