4' Fireplace - Log Installation - continued
Install (2) of the included log placement pins into the far left holes on both ends of log #2
Install (1) of the included log placement pins into the hole second from the right on log #1
Install log #8 as shown below. The pin on log #1 inserts into the hole on the bottom of log #8. Log #8 spans the
burner and the right end angles approximately 45° downward and toward the right (see below).
NOTE: When a log placement requires the log to span the burner,
make sure the part of the log above the burner is not directly above
a cluster of holes (see illustration below).
Install Log #5 as shown below. The log-locating pin on the left of Log #2 inserts into the hole on the bottom of log
#5. Log #5 spans the burner and angles upward and to the right (see below).
Page 14 of 22
DaVinci Birch Log Set
Installation Instructions
17602180
(sku# 94500977)
— 8/21/20
© Travis Industries, Inc.