Troubleshooting - EGO CS1610E Operator's Manual

TROUBLESHOOTING

PROBLEM
Motor does not start.
Chain saw stops running
during working.
Motor runs, but chain
does not rotate.
Chain brake does not
engage.
16
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1610E
CAUSE
◾
The battery pack is not attached to
the chain saw.
◾
There is no electrical contact
between the saw and battery pack.
◾
The battery pack is depleted.
◾
The battery pack or chain saw is
too hot.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is overloaded.
◾
The battery pack or chain saw is
too hot.
◾
Saw chain is bound in the wood.
◾
Chain does not engage drive
sprocket.
◾
Debris preventing full movement of
the chain kickback brake handle.
◾
Possible chain brake malfunction.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to cool
until the temperature drops below 67°C.
◾
Pull the chain-kickback brake handle
backward toward the front handle, arriving
at the operating position.
◾
Press the saw chain against the wood, move
the chain saw back and forth to discharge
the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Decrease the load.
◾
Decrease the load. Allow the battery pack
or chain saw to cool until the temperature
drops below 67°C.
◾
Release the variable-speed trigger switch;
remove the saw chain and guide bar fom
the wood, then restart the chain saw.
◾
Reinstall the chain, ensuring that the drive
links on the chain are fully seated on the
sprocket.
◾
Clean debris from the external chain brake
mechanism.
◾
Contact EGO Customer Service for repair.