ESI -1000 Programming Manual page 18

ESI Communications Servers Programming Manual
Entering programming mode
You may program from any 24-Key or 48-Key Feature Phone
1. Press PROGRAM at any station. The normal station programming menu prompts will begin to play.
2. Press HOLD. The "enter password" prompt will play.
3. Enter the Installer password (default is 7 8 9).
seconds. You are now in programming mode. The extension will be automatically placed in DND, and
its display will show:
INSTALLER
CMD:
4. The system will play the system programming menu. Follow it to program as you wish.
5. When finished, hang up.
Warning: Always FINISH programming in ANY function BEFORE exiting programming mode (as needed, press # to
accept current entries for function parameters you're not changing).
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: If your Installer password is 864, enter programming mode by pressing PROGRAM HOLD 8 6 4 #.
(To exit programming mode, hang up.)
1
Although a 12-Key Feature Phone allows you to enter Installer and Administrator programming, we don't recommend that you use a 12-Key
Feature Phone for programming because of its one-line display and small number of programmable feature keys.
2
If you prefer to enter Administrator programming mode, use the Administrator password, instead (the default is 4 5 6).
System programming: An introduction
1
in the system:
2
Then, to confirm the password, either press # or wait two
D.6