Operation; Volume - Harman Kardon HKTS 6 Owner's Manual

Move the Master Power switch (marked
"Power" ¡) to the " • " (On) position. The
HKTS 6 subwoofer will automatically turn
itself on or go into Standby mode, depend-
ing on whether or not a signal is being sent
to the HKTS 6 by your receiver or surround
processor, and provided that the Auto/On
switch ™ is moved to the left so that it is in
the "Auto" position.
When your receiver or amplifier is off, or is
not sending program material to the sub-
woofer, the subwoofer will be in Standby
mode and the LED ¢ on the amp panel
will turn red. When the subwoofer senses an
audio signal, it will automatically turn itself on
and the LED ¢ will turn green. If the sub-
woofer does not sense a signal after
approximately twenty minutes, it will auto-
matically go into Standby mode.
6
When the Auto/On switch ™ is switched to
the "On" position, the subwoofer will remain
on, whether or not program material is
playing.
If you will be away from home for an
extended period of time, or if the subwoofer
will not be used, switch the Master Power
switch ¡ to the "Off" position.
™ £
6

Volume

Volume can be adjusted using the
Subwoofer Level control £, as shown
below. Turn the control knob clockwise to
increase the volume of the subwoofer and
counterclockwise to decrease the sub-
woofer's volume.
Subwoofer
Level
MIN
Subwoofer
Level
MIN
¢
¡

OPERATION

MAX
MAX
OPERATION 9