Operation - Harman Kardon HKTS 5 Service Manual

HKTS5/HKTS6

OPERATION

Move the Master Power switch (marked
"Power" ¡) to the "
•
" (On) position. The
HKTS 5/6 subwoofer will automatically turn
itself on or go into Standby mode, depend-
ing on whether or not a signal is being sent
to the HKTS 5/6 by your receiver or surround
processor, and provided that the Auto/On
switch ™ is moved to the left so that it is
in the "Auto" position.
SUB-TS5/SUB-TS6
Volume
Volume can be adjusted using the
Subwoofer Level Control £, as shown
below.
MIN MAX
When your receiver or amplifier is off, or is
not sending program material to the sub-
woofer, the subwoofer will be in Standby
mode and the LED ¢ on the amp panel
will turn red. When the subwoofer senses an
audio signal, it will automatically turn itself
on and the LED ¢ will turn green. If the
subwoofer does not sense a signal after
approximately twenty minutes, it will auto-
matically go into Standby mode.
™ £
¢
¡
harman/kardon
When the Auto/On switch ™ is switched to
the "On" position, the subwoofer will
remain on, whether or not program material
is playing.
If you will be away from home for an
extended period of time, or if the sub-
woofer will not be used, switch the Master
Power switch ¡ to the "Off" position.
MIN MAX
4