Table of Contents
Advertisement
5. Slide the alarm unit back into the dedicated slot inside the housing, opposite the buckle. Make
sure to install the alarm unit with the round alarm cylinder facing the housing interior and the
LED pointing outwards, to the back of the housing (image #21 on the previous page).
6. You can test the Moisture Detector by placing a wet finger over the moisture sensor unit at the
bottom of the housing. Once you have confirmed that the alarm is working, gently dry off the
moisture sensor unit. This should silence the alarm.
Important Notice
In case of installing the Fantasea Vacuum Hybrid System inside the housing,
the moisture detector sensor should first be disconnected from the alarm
unit and the alarm unit should be removed from the housing. Please contact
us at
info@fantasea.com
for further instructions.
FG7X III M16 Housing Instruction Manual 20191222
23
Advertisement
Table of Contents
