Panasonic TH-55SQ1W Operating Instructions Manual page 16

3
Using the screw removed in step 1,
fix the function board to the SLOT
adaptor.
●
Tightening torque guideline: 0.5 N·m or less
Note
●
Firmly tighten the screw, and check that the hook of
the SLOT adaptor fixes the circuit board.
●
Check that the surface of the SLOT adaptor and the
surface of the circuit board match with each other
when the function board with the SLOT adaptor
attached is viewed from the opposite side of the
cover.
Make sure that this side is aligned.
Circuit board
×
It cannot be attached unless this side is horizontally
×
16
English
Screw
SLOT adaptor
aligned.
● If there is a lead wire within approx. 3 mm from the
end face of the circuit board, the function board
cannot be attached due to interference with the guide
rail. Ensure that there is no lead wire in this range.
Circuit board
4
Remove the two screws from the main
unit slot cover.
5
Insert the function board to the main
unit slot, and fix it with the two screws
removed in step 4.
●
Tightening torque guideline: 0.5 N·m or less
Approx. 3 mm
No lead wire in this range.
Cover
Screw