ResMed Air10 User Manual page 4

AirSense 10 / AirCurve 10 / Lumis VPAP 100 / Lumis VPAP 150
Refer to illustration B:
1. SD card cover.
2. Air filter cover.
3. Adapter cover.
4. Adapter port.
Setting up
See illustration C:
1. Ensure the device is disconnected from the power outlet.
2. Connect the serial adapter to the device.
3. Connect one end of the serial adapter cable to the serial adapter and the other
to the PDS. Refer to the PDS user instructions for information on setup and use.
4. Reconnect the device to the power outlet.
You can now perform sleep studies. When the sleep studies or data download are
complete, you can remove the serial adapter.
Note:
• To reduce interference with Bluetooth communications, we recommend
placing the Air10 device in Airplane Mode (if available) when using the
Air10 Serial adapter with PDS systems that utilize Bluetooth connections.
• If you need help or to report an unexpected issue, contact a ResMed
representative, ResMed Technical Services or see www.resmed.com.
2