Porter-Cable PCE360 Instruction Manual page 4

• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory
protection.
WARNING:
power sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and
cement and other masonry products, and
• arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well
ventilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust
from power sanding, sawing, grinding,
drilling, and
activities. Wear protective clothing
and wash exposed areas with soap
and water. Allowing dust to get into
your mouth, eyes, or lay on the skin
may promote absorption of harmful
chemicals.
WARNING:
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
protection appropriate for the dust
exposure. Direct particles away from face
and body.
WARNING:
personal hearing protection that
conforms to ANSI S12.6 (S3.19) during
use. Under some conditions and duration
of use, noise from this product may
contribute to hearing loss.
WARNING:
tool for long periods of time. Vibration
caused by the operating action of this
tool may cause permanent injury to
fingers, hands, and arms. Use gloves to
provide extra cushion, take frequent rest
periods, and limit daily time of use.
Some dust created by
other construction
Use of this tool can
Always wear proper
Do not operate this
• The label on your tool may include the
following symbols. The symbols and
their definitions are as follows:
V ....................volts
A ....................amperes
Hz ..................hertz
W ...................watts
min ................minutes
or AC ........alternating current
or DC ....direct current
or AC/DC .alternating or direct current
..................Class I Construction
n o ..................no load speed
n ....................rated speed
..................Class II Construction
...................earthing terminal
...................safety alert symbol
.../min ............per minute
BPM ...............beats per minute
IPM ................impacts per minute
RPM ...............revolutions per minute
SPM ...............strokes per minute
sfpm ..............surface feet per minute
.................Read instruction manual before use
.....................Use proper respiratory protection
.......................... Use proper eye protection
.......................... Use proper hearing protection
MOTOR
Be sure your power supply agrees with
nameplate marking. 120 Volts AC only
means your tool will operate on standard
60 Hz household power. Do not operate
AC tools on DC. A rating of 120 volts AC/
DC means that your tool will operate on
standard 60 Hz AC or DC power. This
information is printed on the nameplate.
Lower voltage will cause loss of power
and can result in over-heating. All Porter
Cable tools are factory-tested; if this
tool does not operate, check the power
supply.
4
(grounded)
(double insulated)