Troubleshooting - Porter-Cable PCE360 Instruction Manual

used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
Problem
• Unit will not start.
• Broken blade stuck
inside clamp.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the Porter-Cable Customer Care Center at (888) 848-5175.

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Broken blade is held in place • Follow the steps under "To
by pin inside clamp.
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment. This Class B digital
apparatus complies with Canadian ICES-
003.
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Porter Cable
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Porter
Cable service center or
authorized servicer.)
• Have cord or switch replaced
at a Porter Cable Service
Center or Authorized Servicer
Remove a Broken Blade" to
disengage pin.
9