Loading Laundry; Adding Detergent And Care Product; Starting The Programme; Soaking Laundry - Siemens WM14VKH1ES User Manual And Installation Instructions

Table of Contents

Advertisement

13.4 Loading laundry
Notes
¡ Please read the information in the
Safety → Page 4 and Preventing
material damage → Page 10 sec-
tions to ensure that you use the
appliance safely.
¡ To prevent creasing, take note of
the maximum load for the
→ "Programmes", Page 26.
Requirement: The laundry is pre-
pared and sorted.
→ "Laundry", Page 35
Open the door.
1.
Make sure that the drum is empty.
Load the laundry unfolded into the
2.
drum.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent to the manual
dosing compartment.
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 10 sections
to ensure that you use the appliance
safely.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Requirement: Find out the optimum
dosage for detergent and care
product.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 19
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press inicio/pausa+carga.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: 0.
13.7 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press inicio/
pausa+carga.
To resume the programme, after
3.
the desired soaking time, press
inicio/pausa+carga.
Basic operation en
39

Advertisement

Table of Contents
loading

Table of Contents