Table of Contents
Advertisement
Fault
Vibrations and move-
ment of the appliance
whilst spinning.
Drum does not turn,
water does not flow in.
Heavy foam build-up
cannot be actu-
ated.
High spin speed not
reached.
The spin programme
does not start.
Cause and troubleshooting
Transit bolts have not been removed.
Removing the transit bolts
▶
Load detection is active.
Not a fault – no action required.
▶
Note: The load detection can take up to two minutes.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 42.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Intelligent dosing is not intended for this programme.
Not a fault – no action required.
▶
Programme progress does not allow intelligent dos-
ing.
No remedial action possible.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
is activated.
menos
Select the programmes that are suitable for the
▶
type of fabric.
→ "Programmes", Page 26
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the centrifugado / centrifugação programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Troubleshooting en
63
Advertisement
Table of Contents
