Examples - Cisco ASR 9000 Getting Started Manual

Chapter 4 Configuring Additional Router Features
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
telnet ipv4 server max-servers limit
Example:
RP/0/RSP0/CPU0:router(config)# telnet ipv4
server max-servers 5
Step 3
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config)# end
or
RP/0/RSP0/CPU0:router(config)# commit

Examples

In the following example, the host services are enabled:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# telnet ipv4 server max-servers 5
RP/0/RSP0/CPU0:router(config)# http server
RP/0/RSP0/CPU0:router(config)# commit
OL-17502-01
F I N A L D R A F T — C i s c o C o n f i d e n t i a l
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
Configuring Telnet and XML Host Services
Purpose
Enters global configuration mode.
Enables Telnet services on the router and specifies the
maximum number of allowable Telnet servers.
Saves configuration changes.
When you issue the end command, the system prompts
•
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the
–
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
– Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
4-5