Step 2: Select Voltage Tap (Zx1I-90T & Zx1I-100T Models Only) - Electro-Voice Zx1i Series Owner's Manual

Step 2: Select Voltage Tap (Zx1i-90T and Zx1i-100T models only)
Before attaching the speaker to the bracket, select the proper voltage tap setting for your
installation. The voltage selector switch is located at the rear of the speaker below the
input terminal panel. The power taps are 100, 50, 25W and 12.5W at both 70.7V and
100V, with a 6W tap for 70.7V only. There is also an 8 ohm bypass setting. The taps are
selected by a rotary switch on the back panel. A guide on the back of each speaker
shows which switch positions to use for the power settings at 70V and 100V. Figure 7
below illustrates the settings.
Voltage Tap
Selector
Voltage Tap
Detail
Figure 7: Voltage Tap Selector (Zx1i-90T and Zx1i-100T Models Only)
®
6 Electro-Voice Zx1i Owner's Manual