Electro-Voice ZX Series ZX1i Assembly And Installation Instructions

TC-ZX1i Terminal Cover
Assembly and Installation Instructions
Weatherized Terminal Cover Kits
M o d l e
T C Z - X i 1 3
T C Z - X i 1 W 3
1. Remove the Nut on the outside of the Terminal Cover.
2. Thread the cable through the Nut and then the Gland and attach to terminals.
3. Remove the top 6 screws from input panel and attach Terminal Cover to speaker using screws supplied with the
Terminal Cover Kit.
4. Tighten the Nut to the Terminal Cover to form a seal around the cable.
Note: In order to form a liquid-tight seal, the cable must have a single, round, cross-sectional jacket. The
diameter of the cable must be between .17 in. (4.32 mm) and .395 in. (10.03 mm). If the diameter of the
cable is larger than .25 in., remove the rubber insert within the gland.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 10/2005
Part Number 38110-516 Rev 1
C a . t N . o
W e a h t r e z i
0 1 9 5 5 0 - 0 1
B a l k c
W e a h t r e z i
0 1 9 5 5 0 - 0 2
W i h e t
ZX1i Enclosure
Screws Torqued
to 10-15 in-lbs
(x6)
Terminal Cover
with Gland Nut
facing down
D e s c i r t p o i
e d t r e m n i a c l o v e f r r o Z X
e d t r e m n i a c l o v e f r r o Z X
U.S.A. and Canada only. For customer orders, contact Customer Service at:
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
Other International locations. For customer orders, contact Customer Service at:
For warranty repair or service information, contact the Service Repair department at:
For technical assistance, contact Technical Support at: 866/78AUDIO
n
i 1 S p e a k r e S s y e t m -
i 1 S p e a k r e S s y e t m -
800/392-3497 Fax: 800/955-6831
+ 49 9421-706 0 Fax: + 49 9421-706 265
+ 1 952 884-4051 Fax: + 1 952 887-9212
Specifications subject to change without notice.
800/685-2606