Table of Contents
Advertisement
EVID Ceiling Speaker Systems
Figure 4.15: Attach auxillary support line except the C4.2LP (left); Attach auxillary support line for the
C4.2LP (right)
4.7
Step 7 — Adjust Tap Selector
The tap selector switch is located on the front baffle. Adjust the speaker to the appropriate
tap setting before installing the grille. In some 70V/100V constant voltage installations it is
advisable to leave the grilles off if final speaker audio level balance adjustments are to be
made later. After the levels are adjusted the grilles can then be installed.
Figure 4.16: Adjust tap selector (left: C4.2/C4.2LP/C6.2/C8.2/C8.2LP; right: C10.1/C8.2HC )
EVID C4.2, C4.2LP, C6.2, C8.2, and C8.2LP
In addition to the 8-ohm setting, the power taps are 30 W, 15 W, 7.5 W, and 3.7 W at both
70.7V and 100V, with a 1.8 W tap for 70.7V only.
EVID C8.2HC and C10.1
In addition to the 8-ohm setting, the power taps are 60 W, 30 W, and 15 W at both 70.7V and
100V, with a 7.5 W tap for 70.7V only.
4.8
Step 8 — Attach the Grille
INSTALLATION NOTE: GRILLE SAFETY FEATURE
EVID grilles features a unique safety tether to prevent the grille from falling if the grille is
removed or comes loose after installation.
First, install the grille's safety tether by pushing the grille fastener into the hole in the front of
the baffle. Second, press the grille into place until the front of the grille is flush with the rim of
the baffle. Make sure the grille is securely seated to prevent it from vibrating loose.
Electro-Voice
Installation manual
Installation and Wiring | en
2018.09 | 11 | F.01U.177.705
17
Advertisement
Table of Contents
