Part One; Owner's Operating Instructions; Start-Up Procedures; Before Start-Up - Raypak 336A Installation & Operating Instructions Manual

PART ONE

OWNER'S OPERATING INSTRUCTIONS

FOR YOUR SAFETY - READ BEFORE OPERATING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
SECTION 1 - START-UP PROCEDURES
Your pool/spa heater has been designed for years of safe and reliable pool/spa water heating. It is available with
millivolt or electronic ignition. ASME-certified units, typically used in commercial applications, are also available.
This manual provides installation, operation, maintenance, and service information for these heaters.
If your heater has been installed correctly, operating the heater is an easy task. The upper front panel of the
heater contains the control center that allows you to turn the heater On or Off and adjust the temperature settings
for the pool or spa. The temperature range is factory set from 65°F (18°C) to 104°F (40°C). See figure above for
location of toggle switch to turn the heater On and Off. Section 4 of this manual contains more details about the
use of the controls in the Control Adjustments subsection (page 32).

BEFORE START-UP

BURNERS
Clean main burners, combustion fan (if equipped)
and air louvers of dust, lint and debris.
heater area clear and free from combustibles, flamma-
ble liquids and chemicals. Do not obstruct the flow of
combustion and ventilation air.
WATER
Water must be flowing through the heater during oper-
Keep
ation. Ensure that the system is filled with water and
that the pump is operating.
4
ON
OFF