Chapter 2 - Terminal Interfaces; Terminal Id - Hand Held Products 3800i User Manual
Industrial handheld linear imager/retail/commercial handheld linear imager
Hide thumbs
Also See for 3800i:
- Application note (32 pages) ,
- Manual (21 pages) ,
- Programming manual (1 page)
Table of Contents
Advertisement
2
Terminal Interfaces
Terminal ID
If your interface is not a standard PC AT, refer to "Supported Terminals" on
page 2-2 through
page
2-3, and locate the Terminal ID number for your PC.
Scan the Terminal ID bar code below, then scan the numeric bar code(s) from
the
Programming Chart
inside the back cover of this manual to program the
scanner for your terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the
Programming Chart
inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the
Programming
Chart, scan
the Terminal ID bar code, scan the digits, and the Save code again.
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
3800i/3800r User's Guide
2 - 1
Advertisement
Table of Contents
