Other Programming Selections; Data Format Editor Commands - Hand Held Products 3800i User Manual
Industrial handheld linear imager/retail/commercial handheld linear imager
Hide thumbs
Also See for 3800i:
- Application note (32 pages) ,
- Manual (21 pages) ,
- Programming manual (1 page)
Table of Contents
Advertisement
inside back cover to program the scanner for your terminal ID (you must
enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
In the
Appendix
data format. Locate the Hex value for that symbology and scan the 2
digit hex value from the
this manual.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the
ming Chart
entered as 0050. 9999 is a universal number, indicating all lengths.)
Step 6. Editor Commands
Refer to the Format Editor Commands Chart
bols that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7. Scan Save from the
manual to save your entries.
Other Programming Selections
• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the
primary format, scan 0 from the
this manual. If you are clearing an alternate format, scan 1, 2, or 3, depending
on the alternate format you are clearing. Scan the Terminal Type (refer to the
Supported Terminals Chart on
Chart
on page A-1), and the bar code data length for the specific data format
that you want to delete. All other formats remain unaffected.
• Save from the
This exits, saving any Data Format changes.
• Discard from the
This exits without saving any Data Format changes.
Data Format Editor Commands
Send Commands
F1 Send all characters followed by "xx" key or function code, starting from cur-
rent cursor position. Syntax = F1xx (xx stands for the hex value for an
ASCII code, see
F2 Send "nn" characters followed by "xx" key or function code, starting from
current cursor position. Syntax = F2nnxx (nn stands for the numeric value
5 - 2
A, find the symbology to which you want to apply the
Programming Chart
inside the back cover of this manual. (Note: 50 characters is
Programming Chart
Programming Chart
Programming Chart
ASCII Conversion Chart (Code Page 1252)
inside the back cover of this
Programming Chart
page
2-2), Code I.D. (refer to the
inside the back cover of this manual
inside the back cover of this manual
inside the back cover of
Program-
(page
5-2). Scan the sym-
inside the back cover of
Symbology
on page A-2.)
3800i/3800r User's Guide
Advertisement
Table of Contents
