When Check Character is set to Validate and Transmit , the scanner will only
read MSI bar codes printed with the specified type check character, and will
transmit this character at the end of the scanned data.
When Check Character is set to Validate, but Don't Transmit , the unit will only
read MSI bar codes printed with the specified type check character, but will not
transmit the check character with the scanned data.
* Validate Type 10, but Don't
Transmit
Validate Type 10 and Transmit
MSI Message Length
Scan the bar codes below to change the message length. Refer to
Message
Length
on page 7-2 for additional information. Minimum and Maximum
lengths = 4-48. Minimum Default = 4, Maximum Default = 48.
Minimum Message Length
Maximum Message Length
Plessey Code
<Default All Plessey Code Settings>
Plessey Code
On
* Off
3800i/3800r User's Guide
7 - 27