Cisco 7513 Quick Start Manual page 14

Install the Hardware
Connect AC-Input Power Supply
Warning
12
power supply should be off.
Step 1
For AC-input power supplies, push the
cable retention clip away from the power
receptacle and plug in the power cable.
Step 2
Push the cable retention clip until it snaps
into place around the cable connector.
Step 3
Reconnect the power cable at the power
source, remove the tape on the breaker
switch. Do not turn on the breaker or
power to the power supply.
AC FAN
OUTPUT
OK
OK
FAIL
The system power switch on the
Cable-retention clip
AC FAN
OUTPUT
OK
OK FAIL
Captive screws
Note
A power supply blank must remain in any
empty power supply bay.
Step 4
Repeat Step 1 through Step 3 for the
second power supply, if present.
Note
Do not mix AC-input and DC-input power
supplies in the same chassis.
POW ER
B