WeTech WTC1701 User Manual

USER MANUAL

WTC1701

Article number: 600202

Thank you for purchasing a WeTech® product. This user manual contains important safety

and operating instructions for your Passiv charger. Before using your charger, read this

manual and all warning instructions with care in order to avoid possible danger.

This product is suitable for the charging of VERTEX VX-925E-DO-1, VX-925E-DO-5, EVX-

531-G6-5 and VX-451-G6-5 radio units with FNB-V129LI-UNI, FNB-V128LI-UNI, FNB-

V127LI-UNI, FNB-V133LI-UNI and FNB-V134LI-UNI batteries.

Table of Contents

Need help?

Do you have a question about the WTC1701 and is the answer not in the manual?

Page 1 WTC1701 Article number: 600202 Thank you for purchasing a WeTech® product. This user manual contains important safety and operating instructions for your Passiv charger. Before using your charger, read this manual and all warning instructions with care in order to avoid possible danger.
Page 2 Under no circumstances should you use water or other liquids. Scope of delivery The following items are included in the scope of delivery: Passiv-Charger WTC1701 Holding bracket for WTC1701 Passive accessory set Start of the sy stem Passive accessory set Connect the strands (1) of the DC cable provided to mains power.
Page 3 Functions The charging bracket is used for quick charging and maintaining charge. The table below provides information about the function of the displays and the connections of the unit. Pos. Designation Status Description Green LED Battery detected. Battery not detected. Contact with the radio unit may not have been established properly.
Page 4 The correct disposal of this product supports environmental protection and prevents possible damage to the environment and human health. Contact This product was manufactured in Germany by: WEMPE Elektronic GmbH phone: +49 6621 9240-0 Leinenweberstr. 6 fax: +49 6621 9240-44 DE-36251 Bad Hersfeld website: www.wetech.de e-mail: info@wetech.de Made in Germany...

600202