Table of Contents
Advertisement
I-310e – UserManual
Installation
Cover Removal
To open the Model I-310e use a coin in the slot on the
bottom to release the snap. Lift the cover up slightly to
disengage the closure and remove cover with a downward
motion to clear the catch at the top of the unit.
The locations of controls and terminals on the main circuit
board are shown in the Figure 2 on page 4.
Mounting
The Model I-310e is designed for flush mounting with two
fasteners. The locations of the mounting points (shown in
Figure 1) allow direct mounting on a standard simplex
(single circuit) junction box. There is a wiring cutout in the
center of the unit near the terminal strips.
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. |
Figure 1: AirSense Model I-310e Mounting Dimensions
DCS, Inc. | PRE 200217 | Page 6 of 17
©
Advertisement
Table of Contents
