Table of Contents
Advertisement
CI-24 – Installation
Specifications subject to change without notice. | 86-0468-00r3 9/99 | USA 150729 | Page 3 of 8
INSTALLATION
TURN POWER OFF AT CIRCUIT BREAKER BEFORE INSTALLING SENSOR
Mask secures
to pins on cover
12'
A 4-S junction box can be used with a 3" mud-ring when local building codes
mandate that low voltage connections be contained in a junction box.
Otherwise a 3" mud-ring or the provided ceiling attachment ring can be used.
IMPORTANT: If the lens will be masked, the junction box or mud ring may
need to be positioned so that the mask is oriented properly when the sensor is
installed (see Masking).
Cut a hole in the ceiling tile—if using a:
•
Ceiling attachment ring (provided)—cut about 2-3/4" to 3" in diameter.
•
3" mud ring—cut the hole to accommodate.
To assemble the sensor:
1. If using the ceiling attachment ring, bend the securing straps up so the sensor
housing can be inserted, and attach it to the sensor with the provided screws.
2. Attach the mask, if using, into the lens recess and onto the securing pins of
the cover.
3. Attach the cover to the rear housing—align tabs on inside of cover to
notches on outside perimeter of rear housing, place cover on sensor, and
twist clockwise to lock.
4. Insert the assembled sensor into the ceiling hole, and if using the mask,
turn the sensor so that the unmasked part of the lens is toward and cen-
tered on the area to be covered.
5. Bend the ceiling attachment ring straps behind the hole to secure (or
attach sensor to mud ring with screws).
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
≠
CAUTION
Ceiling
≠
2-3/4" to 3" hole
(if using 3" mud-ring,
cut to accomodate)
Ceiling attachment ring
(bend behind ceiling
to secure)
Rear housing
Mask (optional)
cut for desired coverage
Cover (with lens)
MASKING
An insert (mas
The mask is cu
IMPORTANT:
IMPORTANT:
assembled se
faces the cov
IMPORTANT:
then the mask
(note the loca
turns as it loc
Note: At the e
illustrated as t
Cut mask into s
for desired cove
shown right.
WIRING
TURN POWER
•
Connect 2
wire from t
Isolated Relay
Connect the w
•
GREEN (N
•
ORANGE (
•
YELLOW (
24
Isola
No
Co
No
24
Advertisement
Table of Contents
