LaserLiner ActiveFinder XP User Manual page 9

– Do not work alone in the vicinity of hazardous electrical installa-
tions and only under the guidance of a qualified electrician.
– The measuring device must not be used as a substitute for a
two-pole zero potential test.
– The device measures the presence of electrostatic fields of
sufficient strength. If the field strength is too low voltage may still
be applied although no warning signal is given. The following list
of factors that influence the field strength does not claim to be
complete: shielding, cable insulation (type, thickness), measure-
ment distance, insulation between user and earth, special socket
designs, condition of tester and of batteries.
Additional information on use
Observe the technical safety regulations for working on electrical
systems, especially: 1. Safely isolating from power supply,
2. Securing to prevent system being switched on again,
3. Checking zero potential, two-pole, 4. Earthing and short-
circuiting, 5. Securing and covering adjacent live components.
Safety instructions
Using artificial, optical emission (OStrV)
LED outlet
– The device works with LEDs of risk group RG 0 (exempt, no risk)
in accordance with the latest versions of applicable standards
relating to photobiological safety (EN 62471:2008-09ff / IEC/TR
62471:2006-07ff).
– Radiation power: Peak wavelength equals 453 nm.
Mean radiance is below the limit values of risk group RG 0.
– When used for the intended purpose and under reasonably
foreseeable conditions, the accessible radiation of the LEDs
is safe for the human eye and skin.
– Temporary, irritating optical effects (e.g. dazzling, flash blindness,
afterimages, colour vision impairment) cannot be completely ruled
out, especially under low ambient light conditions.
– Do not intentionally look directly into the radiation source for
longer periods of time.
– No specific measures are required to ensure the limit values
of risk group RG 0 are maintained.
ActiveFinder XP
09
EN