How To Clean - Cuckoo CRP-CH10 Fuzzy Series Operating Instructions Manual

- To prevent foul odor clean the lid assy after the rice cooker has cooled and the rice cooker is unplugged.
- Clean the body of rice cooker and the cover with a dry towel. Do not use benzene or thinner to clean the
rice cooker. The layer of starch, which is the residue from rice cooking, may appear on the detachable cover
or inside of rice cooker. This layer does not cause any health risk.
- Do not put materials like screws into holes of detachable cover. Check the back cover and front cover.
Detachable cover & Pressure packing
After cleaning detachable cover, put it back on the lid
Unless detachable cover is mounted, preset cooking cannot be done. (Alarm may sound while keeping warm.)
② Wash the cover with cooking
① Turn the holder counter
purposeneutral detergent and
clock wise, and the cover
will be easily separated
sponge frequently, and wipe
from the cooker and can
off moisture with handkerchief.
be washed.
③ Please keep clean the edge of
rubber packing, then the rice
cooker last's longer.
Please fir a rubber packing into the cover plate completely after washing or replacing the rubber packing.
Rubber packing guide
① To separate the rubber packing, ② To put back the rubber packing,
please pull it out from the cover
plate as shown in the picture.
Steam Vent
Make sure to clean the clean steam
went after/before use. Do not try to
pull out the clean steam went and
safety packing, clean it with care.
Make sure the clean steam went
and safety packing are installed
completely after/before use. If the
steam vent is detached, or not
attached completely, please contact
customer service.
Detachable cover & Pressure packing
1. Handle must be turned to "
When the lamp is turned on it means that it is ready to cook.
2. After cooking, turn the handle from "
turn the handle to open. If there is unreleased steam in the Inner pot
it might be hard to turn the handle. In this case twist the pressure
weight and let the excess steam out. Do not open by force.
. Handle must be turned to "
Inner pot
contact surface.
④ When mounting the cover,
grab separate cover handle,
attach it to hole, and after
adjusting holder on top of
packing stop tab, fix it by
turning it clockwise.
Detachable cover point
③ After fitting 6 projections to the holes, please
please fit it to each of 6 projections
press the rubber packing around the corner
and holes as shown in the picture. Inner Pot
completely as shown in the picture.
Rubber packing
contact surface.
Wipe the water on the outside and
bottom of the Inner Pot. A rough
sponge, a brush or an abrasive can
cause scratches on the coating. Use
a dishwashing liquid and a soft cloth
or a sponge.
※ Keeping the contact area of the Inner Pot with the pressure
packing always clean, increases the product's durability.
"(Lock) during Cooking.
"(Lock) to "
"(Unlock) when opening and closing.

HoW to Clean

⑤ It is easier to attach the
cover holder when the
power part of the
detachable cover is
pressed.
④ Please check that the rubber packing fits into the
cover plate completely. If not, steam may be released
Pressure Packing
from the crack between the packing and the plate.
Wipe the main unit with a wet cloth
that has been extracted out of all
water
•If the lamp does not turn on, it would not
operate the "PRESSURE COOK" and
"(Unlock)
'PRESET/AUTO CLEAN' buttons. Make
sure the handle is located in "
HOLDER OPEN
HOLDER CLOSED
※ As depicted in the
picture, please
align holder with
arrow mark to
open and close.
Inside of the Main body
Make sure to clean the steam
control went before and after use.
"(Lock).
Lock
43