Ransburg 9040 Service Manual page 6

9040 Low Voltage Control Unit Kit- Safety
AREA
Tells where hazards
may occur.
General Use and
Maintenance
Electrical
Equipment
3
HAZARD
Tells what the hazard is.
Improper operation or maintenance Personnel must be given training in accordance with
may create a hazard.
Personnel must be properly trained Instructions and safety precautions must be read and
in the use of this equipment.
High voltage equipment is uti-
lized. Arcing in areas of
flammable or combustible
materials may occur. Personnel
are ex-posed to high voltage during
operation and maintenance.
Protection against inadvertent
arcing that may cause a fire or
explosion is lost if safety circuits material.
are disabled during operation.
Frequent power supply shutdown as instructed.
indicates a problem in the sys-tem
which requires correction.
An electrical arc can ignite coat-
ing materials and cause a fire or Before turning the high voltage on, make sure no
explosion.
SAFEGUARDS
Tells how to avoid the hazard.
the requirements of NFPA-33 or European norms.
understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, operation
maintenance, and housekeeping. Reference OSHA,
NFPA-33, European Norms, and your insurance
company requirements.
The power supply, optional remote control cabinet,
and all other electrical equipment must be located
outside Class I or II, Division 1 and 2 or Zone 1
hazardous areas. Refer to proper European Norm
or NFPA 33.
Turn the power supply OFF before working on the
equipment.
Test only in areas free of flammable or combustible
Testing may require high voltage to be on, but only
Production should never be done with the safety
circuits disabled.
objects are within the sparking distance.
CP-11-01