Ransburg 9040 Service Manual page 11

The 9040 Cascade control unit has also been
modularly designed so that two half rack 9040
chassis will fit into one full rack enclosure, in
multiple applicator installations. The full rack
enclosure has been designed for mounting in
standard 19-inch rack mount cabinets.
The 9040 Control
applications includes an additional normally open
pressure switch (3PS) connected between fuse
1FU and ON/OFF switch 1SW. The air input to
this pressure switch is located at the rear of the
control unit and is labeled 3PS. When the air
**Note:CE/Atex approval with this power source is only for the AEMD-500
80072-ABC (Atex approved when used with AEMD500)
A-Unit Power Type
B- High Voltage Cable Length
C-Low Voltage Cable Length
80078-ABC (Not Approved)
A-Unit Power Type
B- High Voltage Cable Length
C-Low Voltage Cable Length
CP-11-01
9040 Low Voltage Control Unit Kit- Introduction
Unit Kit for automatic
9040
Kit # Used with Applicator Type
80072-1XX** Esta-Quick (110/120 V inputs)
80072-2XX** Esta-Quick (220/240V inputs)
80078-1XX Evolver SE (110/120 V inputs)
80078-2XX Evolver SE (220/240 V inputs)
9040 Low Voltage Control Unit Kit Part Structure
-1 For 110/120 V Input Power (USA)
-2 For 220/240 V Input Power
-1 For 4.5 m (15 ft.)
-2 For 7.5 m (25 ft.)
-3 For 15 m (50 ft.)
-4 For 22.5m (75 ft.)
-1 For 3 m (10 ft.)
-2 For 7.5 m (25 ft.)
-3 For 11 m (36 ft.)
-1 For 110/120 V Input Power (USA)
-2 For 220/240 V Input Power
-1 For 4.5 m (15 ft.)
-2 For 7.5 m (25 ft.)
-3 For 15 m (50 ft.)
-4 For 22.5m (75 ft.)
-1 For 3 m (10 ft.)
-2 For 7.5 m (25 ft.)
-3 For 11 m (36 ft.)
signal is removed from this input, the contacts of
the pressure switch are open and AC power to the
control unit is disconnected.
The 9040 Cascade Control Unit is available for
automatic applicators as follows:
Applicator #
AEMD-500
AEMD-500
A12455
A12455
8