Remote Controller; Preparation - Kenwood DMX709S Instruction Manual

Settings Settings
<Application Version>
Updates the system application.
<System Version>
Updates the system.
<GNSS Version>
Updates the Global Navigation Satellite firmware.
<HD Radio Version> (Only for DMX709S)
Updates the HD Radio firmware.
• Do not disconnect the USB device while updating.
• If the update has failed, turn the ignition switch off
then on, and retry the update.
<Open Source Licenses>
Shows the Open Source Licenses.

Remote Controller

Remote Controller
To use the remote controller, purchase optional
remote controller, KCA-RCDV340.
• When using the remote controller, refer also to
the instruction manual supplied with the remote
controller.
Remote sensor*
* DO NOT expose the remote sensor to bright
V.SEL
MODE FNC/PBC
DVD SETUP RETURN
light (direct sunlight or artificial lighting).
AUDIO ANGLE
KCA-RCDV340
CAUTION
• Do not leave the remote controller in hot places such
as on the dashboard.
• Risk of the fire of explosion if the battery is replaced
by an incorrect type. Ensure to replace only with the
same type.
• Risk of fire, explosion or the leakage of flammable
liquid or gas if the battery is left in an extremely
high temperature surrounding environment and/
or subjected extremely low air pressure. The battery
pack or batteries shall not be exposed to excessive
heat such as sunshine, fire or the like
• Risk of fire, explosion or the leakage of flammable
liquid or gas if the battery is disposed into fire or a
hot oven, recharged, shorted, mechanically crushed
or cut of the battery.
• If spilled fluid comes in contact with your eyes or on
clothing, immediately rinse with water and consult
a physician.

Preparation

Battery installation
Use two "AAA"/"R03"-size
batteries.
Insert the batteries with the +
and – poles aligned properly,
following the illustration inside
the case.
• Always insert batteries from
– poles to avoid bending the
springs.
ENGLISH 51