MacDon R80 Manual page 13

h. Cut all banding at header front covers. The
two center bands also secure the forming
shield top cover inside the header.
i. Remove five bolts and nuts on each door and
remove front angles and lift hooks.
lower side bolt (A) for re-installation at same
location after hook is removed.
j. Open cutterbar doors fully.
k. Remove shipping wire holding forming shield
top cover to header.
Form # 169080
UNLOADING AND ASSEMBLY
l.
A
Retain
11
Slide top cover out from front of header and
set aside for later installation.
Issue – April 2007