Cleaning the overflow filter
2. Take off the corrugation pipe.
Dismantle the upper part of the
overflow filter ( as indicated in
3. Cleaning the overflow filter
Clean the lint around the filter
and flush with tap water.
4. Install the overflow filter.
(1).Install the corrugation pipe.
(2).Insert the mounting plate at
the bottom of the filter into
(3).Hang up the hook at the left
(4).Push the upper part in as
indicated in Figure 2.
Disposal of the complete unit
Wipe the complete unit with soft cloth
Wipe with neutral detergent if too dirty
Do not wash it directly by water
After washing, dismount the water inlet
Do not store water in the tub for long
period. Discharge the water immediately
after each using.
Pull off the power plug and hang up the
Hang up the drain hose.
Wipe off the water drops on the surface
and inside the tub with clean soft cloth.
Open the cover of the wash tub and the
inner/outer cover of the spin tub for
some time (about one hour), then close