Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the ! Start/Reload
button. The washing machine checks
whether adding laundry is possible.
If the following appears in the display
panel:
Both the YES and v symbols light
■
up, it is possible to add laundry.
NO flashes, wait until the YES and v
■
light up. Do not open the washing
machine door until both the YES
and v symbols are lit.
NO lights up, it is not possible to add
■
laundry.
Notes
For safety reasons, the washing
■
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry
during this time.
To continue the programme, select
the ! Start/Reload button.
Do not leave door open for
■
a prolonged period – water could
run out of the laundry.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press ! Start/Reload.
1.
Select the other programme.
2.
Press ! Start/Reload . The new
3.
programme starts from the
beginning.
Operating the appliance
Cancel the programme
For programmes at high temperature:
Select ! Start/Reload.
1.
To cool down laundry: Select
2.
q Rinse.
Select ! Start/Reload.
3.
For programmes at low temperature:
Select ! Start/Reload.
1.
Select 0 p Spin/Empty (if only
2.
a drained cycle is required: set rpm
(spin speed) to - - -).
Select ! Start/Reload.
3.
Programme end during rinse
hold
- - - appears in the display panel and the
! Start/Reload button indicator light
flashes.
To end the programme:
Select 0 p Spin/Empty (if only
1.
a drained cycle is required: set rpm
(spin speed) to - - -).
Select ! Start/Reload.
2.
Programme end
End appears in the display panel.
If the x symbol also appears in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
en
19