Table of Contents
Advertisement
Faults and what to do about them.
en
Information on the display panel
Display
YES
NO
E:17
E:18
E:23
w
x
:
.
Other displays
Faults and what to do about them.
Faults
Water is running out.
Water not flowing in.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
26
Cause/Remedy
The washing machine door is unlocked. It is possible to add laundry.
Due to the high temperature in the drum, the washing machine door cannot
■
be opened. Wait until the temperature drops.
Due to the high level of water in the drum, the washing machine door can-
■
not be opened. Drain the water e.g. select the 0 p Spin/Empty pro-
gramme (if only a drain cycle is required, set rpm (spin speed) to - - -).
Turn on tap fully, supply hose kinked/jammed; water pressure too low, clean fil-
ter ~ Page 24
Drain pump blocked; clean the drain pump~ Page 23
Drainage hose/outlet pipe blocked; clean drainage hose on the siphon
~ Page 24
Water in the base trough, appliance leaking. Call after-sales service.
~ Page 28
If childproof lock is active, deactivate it ~ Page 18
~ flashes: Too much foam detected?~ Page 26
~ flashes: Mains voltage too low ~ Page 22
~ flashes: Undervoltage during the washing programme. The programme
duration is extended. ~ Page 22
Switch off the appliance, wait for five seconds and switch it back on again. If the
indicator appears again, call the after-sales service ~ Page 28
Cause/Remedy
Attach/replace the drain hose correctly.
■
Tighten the screw-fitting on the supply hose.
■
! Start/Reload not selected?
■
Tap not open?
■
Filter may be blocked? Clean the filter. ~ Page 24
■
Supply hose kinked or trapped?
■
Safety function active. Stop programme?
■
– – – (Rinse stop = without final spin cycle) selected? ~ Page 19
■
Can be opened by emergency release only?
■
! Start/Reload or 0 (Ready in) time selected?
■
Washing machine door closed?
■
Childproof lock active? Deactivate. ~ Page 18
■
Advertisement
Table of Contents
