ECS P4IBAS2 Manual page 66

Resources Controlled By (Auto(ESCD))
You should leave this item at the default Auto(ESCD). Under
this setting, the system dynamically allocates resources to
Plug and Play devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture)
expansion card to work properly, you might be able to solve
the problem by changing this item to Manual, and then open-
ing up the IRQ Resources and Memory Resources submenus.
In the IRQ Resources submenu, if you assign an IRQ to Leg-
acy ISA, then that Interrupt Request Line is reserved for a
legacy ISA expansion card. Press <Esc> to close the IRQ Re-
sources submenu.
In the Memory Resources submenu, use the first item R e-
served Memory Base to set the start address of the memory
you want to reserve for the ISA expansion card. Use the sec-
ond item Reserved Memory Length to set the amount of
reserved memory. Press <Esc> to close the Memory Re-
sources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be
caused by some non-standard VGA cards. This board i n -
cludes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ For USB (Enabled)
Names the interrupt request (IRQ) line assigned to the USB
on your system. Activity of the selected IRQ always awakens
the system.
INT Pin1~8 Assignment (Auto)
Names the interrupt request (IRQ) line assigned to a device
connected to the PCI interface on your system.
60