ECS P4IBAS2 Manual page 34

Note: Before installing an add-on card, check the docu-
mentation for the card carefully. If the card is not
Plug and Play, you may have to manually configure
the card before installation.
1. Remove a blanking plate from the system case corre-
sponding to the slot you are going to use.
2. Install the edge connector of the add-on card into the
expansion slot. Ensure that the edge connector is cor-
rectly seated in the slot.
3. Secure the metal bracket of the card to the system
case with a screw.
Note: For some add-on cards, for example graphics adapters
and network adapters, you have to install drivers and
software before you can begin using the add-on card.
28