Setting The Water Softener Level - Baumatic SUPREMA1SS/W User Manual

o It is perfectly normal for a small amount of water to come out of
the water softener container, whilst you are filling it with salt.
This does not mean that the container is filled with the correct
amount of salt.
o Refit and fully tighten the water softener cap.
o The salt required warning light will go out approximately 2-6
hours after you have filled the water softener with salt. When
the salt indicator neon lights on the control panel, then you
should follow the filling with dishwasher salt procedure again.
o IMPORTANT: You do not need to pour 1 litre of water into
the container when you subsequently fill the water
softener with salt.

Setting the water softener level

It is possible to regulate the amount of salt that the water softener will
release during a wash cycle. The water softener should be set to a
level that is appropriate for the hardness of your water (please refer to
the table below).
To alter the amount of salt that is released by the water softener, you
should:-
o Remove the lower basket and unscrew the cap from the water
softener container.
12
o Locate the ring with an arrow on it that is
located on the water softener container. (See
figure opposite).
o When you first receive your appliance, the
arrow will be pointing to the minus symbol.
Using the water hardness chart, you should turn
the arrow to the setting that is appropriate for
your water hardness.