Setting The Water Softener Level - Baumatic BFD64SS Instruction Manual

o The salt required warning light will go out approximately 2-6

Setting the water softener level

It is possible to regulate the amount of salt that the water softener will
release during a wash cycle. The water softener should be set to a
level that is appropriate for the hardness of your water (please refer to
the table below).
To alter the amount of salt that is released by the water softener, you
should:-
o Remove the lower basket and unscrew the cap from the salt
o The "middle" selector position is halfway between the minus and
o If your water is already sufficiently soft or you are going to
Downloaded from www.Manualslib.com
hours after you have filled the salt container with salt. When the
salt required warning light comes on again, then you should
follow the filling with dishwasher salt procedure again.
IMPORTANT: you do not need to pour 1 litre of water into
the container when you subsequently fill the water
softener with salt.
container.
o Locate the ring with an arrow on it that is
located on the salt container. (See figure
opposite).
o When you first receive your appliance, the
arrow will be pointing to the minus symbol.
Using the water hardness chart, you should
turn the ring anti-clockwise to the setting that
is appropriate for your water hardness.
plus symbols.
exclusively use the 3 in 1 wash program in conjunction with 3 in
1 dishwasher tablets, then the ring can be turned to any
position. However the salt container should not be filled with
salt.
manuals search engine
12