Related Manuals for Haier 50FREE-3
Summary of Contents for Haier 50FREE-3
- Page 1 Fully Automatic Washing Machine This manual is for 50FREE-3 Please read this manual carefully before using. Retain it for future reference.
-
Page 2: Packing List
Contents Names of the parts Safety precautions Installation and adjustment Install the water inlet hose Preparation before washing Put in the laundries Add the detergent Use the operation buttons Close the top lid Washing finished Disposal after washing Trouble shooting Answer to question Packing list Specification table Specification... -
Page 3: Trouble-Shooting Answer To Question
Trouble-shooting answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. -
Page 4: Safety Precautions
Safety precautions Please insert the power cord into special rece- The power cord plug should be convenient ptacle with rated voltage.If the power cord is to be pluged in or pluged out with hand three-phase wire,please use three-phase rec- while the washing machine runs normally. eptacle.The earthing terminal of the receptacle Be sure to pull the plug out and close the must be earthed reliably.If it is two-phase wire,... -
Page 5: Close The Top Lid
Water Level and Time Table for Each Program (self programming not included) Water Rinse(minutes) Program Wash(minutes) level Rinse twice, about 17 STANDARD About 18 Saving water program, total about 10 minutes Save Rinse twice, about 17 GENTLE About 6 SOAK+WASH Rinse twice, about 17 HEAVY about 40... -
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the inner cover 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. - Page 7 Steps of using the operation buttons and description of the steps 1 Push the POWER ON/OFF button to switch on the power After switching on the power,DISINFECT is not selected To select DISINFECT,push WATER LEVEL/DISINFECT over 2 seconds, the DISINFECT function works,then push 2 or 3 to select a suitable program. 2 Push the PROGRAM SELECTION button to select the suitable automatic program After switching on the power, the machine will set to STANDARD program automatically.
-
Page 8: Install The Water Inlet Hose
Install the water inlet hose 1. Attach the water inlet hoses to the water faucet. Using pliers, tighten the coupling. ( As figure 1) NOTE: Do not over tighten. Damage to the valves can result. 2. Connect the other ends to the water inlet valve . ( As figure 2) Jointer of the water inlet hose Jointer of the... -
Page 9: Use The Operation Buttons
Installation position. Take down the water inlet hose 1.Close the water tap. 2. Pull off the water inlet hose from the water tap and washer Push the RINSE button to set the rinse procedure. During STANDARD... -
Page 10: Preparation Before Washing
1 Preparation before washing Preparation before washing 1.Connect the water inlet hose and open the water tap . 2.Confirm that the washing machine isearthed reliably . The insert the powerplug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose.