Haier 50FREE-3 User Manual page 7

b
Steps of using the operation buttons
and description of the steps
MIN
1 Push the POWER ON/OFF button to
switch on the power
After switching on the power,DISINFECT is not selected
To select DISINFECT,push WATER LEVEL/DISINFECT over 2 seconds,
the DISINFECT function works,then push 2 or 3 to select a suitable program.
2 Push the PROGRAM SELECTION button to
select the suitable automatic program
After switching on the power, the machine will set to STANDARD program automatically. To select other
program, push the PROGRAM SELECTION button till the corresponding indicator is on. Refer to the
PROGRAM SELECTION button in Page 11.
For example: select QUICK WASH for the quick washing of SAVE wash
the laundries with light dirt.
3 Push WASH RINSE SPIN button to select
suitable programs
12
POWER
ON/OFF
START
PAUSE
POWER
ON/OFF
PROGRAM
Page11
MIN
How to change the direction of the drain hose
1.Lean the machine down gently with the front
surface facing the ground. Loosen the eight
screws by a cross screwdriver.
Back
Front
2.Pull out the drain hose from the groove at the
right side.
Use groove at
this side after
direction changing
Usage of the drain hose
The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not trample or press the drain hose.
If the drain hose is too long, cut it at mid
POWER
point. To make smooth drainage, cut the
ON/OFF
front end of the hose slantingly.
START
PAUSE
3.Extend the drain hose from the left side. Push the
drain hose into the groove with hands.
Bottom plate
Push the drain hose
into the groove with
Soft item
4.Install the bottom plate (as per indicated before),
then lift the machine up gently.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 26mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
5