Commissioning; Oil Supply - ABB HT574400 Operation Manual

Operation Manual / 4 Product description / A100-M axial
3

Commissioning

3 Commissioning
3.1

Oil supply

3.1.1 Introduction
In all operating states, a functioning and carefully executed oil supply is an important prerequi-
site for trouble-free operation of the turbocharger.
The lubrication of the turbocharger is usually carried out with oil from the engine oil circulation.
Follow the enginebuilder's specifications on the selection of the lubricating oil and the oil

change intervals.
For more information on the oil supply, refer to Chapter Oil pressure, oil temperature [➙ 23].
3.1.2 Pre-lubrication and post-lubrication
The pre-lubrication time is at least 2 minutes.
The post-lubrication time is 10 minutes.
If the engine is operated in idle mode 10 minutes before stopping, no additional post-
lubrication is required.
3.1.3 Oil filtering
Filtering of the lubricating oil with a filter mesh width of ≤ 0.050 mm is sufficient for the turbo-
charger.
3.1.4 Oil pressure
Comply precisely with the oil pressure before the turbocharger for trouble-free operation.
© Copyright 2016 ABB. All rights reserved. HZTL4033_EN
Page 19 / 113
Revision A July 2016