Using The Reset Button - Cisco Wireless Express 526 Quick Start Manual

Message Type
Controller image
upgrade
Controller crash
Controller boot error Off

Using the Reset Button

The Reset button on the controller's front panel becomes active after the controller boots. You can use
the Reset button to reset power or to reset the configuration to factory defaults.
Resetting Controller Power
Follow these steps to reset power to the controller using the Reset button:
Place a straightened paper clip into the Reset button hole.
Step 1
While observing the controller LEDs, gently push and hold the Reset button with the paper
Step 2
clip.
Step 3 When the Status LED turn amber, release the Reset button by removing the paper clip.
The controller configuration settings are not reset. If you have configured the controller, it
reboots and loads the active configuration. If you have not configured the controller, the
startup wizard GUI appears.
Resetting the Controller to Factory Defaults
Follow these steps to reset the controller to factory defaults using the Reset button:
Place a straightened paper clip into the Reset button hole.
Step 1
While observing the controller LEDs, gently push and hold the Reset button with the paper
Step 2
clip.
22
AP Alarm
LED LED
Off Off
Off Off
Off Amber
Off
Status
LED Meaning
Blinking Controller image is being upgraded.
amber
Green Controller image upgrade is complete.
Green The controller software has crashed.
Amber The controller has experienced a boot error.