The display shows the calculated cooking time.
‒
You cannot change the cooking time.
On some programmes, you can delay the end
‒
time using .
→ "Setting the end time", Page 20
To change the programme, press
‒
a After a few seconds, the programme starts and the
cooking time counts down.
20 Childproof lock
Secure the appliance to prevent children from accident-
ally switching it on or changing the settings.
Notes
¡ The option to set the childproof lock can be activ-
ated in the Basic settings → Page 17.
¡ After a power cut, the childproof lock will no longer
be active.
21 Basic settings
You can configure the basic settings for your appliance to meet your needs.
21.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display
1
Factory setting (may vary according to model)
21.2 Changing basic settings
Requirement: The appliance is switched off.
1.
Press and hold the
four seconds.
a The first basic setting appears in the display,
e.g. .
2.
Use the
or
button to change the setting.
3.
Use the
button to switch to the next basic setting.
.
Basic setting
Signal duration upon completion of a
cooking time or timer period
Acoustic signal when a button is
pressed
Cooling fan run-on time
Waiting time until a setting is adop-
ted
Childproof lock can be adjusted
→ "Childproof lock", Page 23
button for approx.
a If the programme has ended, an audible signal
sounds and the display shows the cooking time as
zero.
6.
When the programme ends:
Press any button to end the signal prematurely.
‒
To set a cooking time for further cooking,
‒
press . The appliance will resume heating us-
ing the programme settings.
When the dish is ready, switch off the appliance.
‒
20.1 Activating and deactivating the
childproof lock
Requirement: The function selector must be set to the
off position.
▶
To activate the childproof lock, press and hold the
button until
appears in the display.
To deactivate the childproof lock, press and hold
‒
the
button until
Selection
= 10 seconds
= 30 seconds
= 2 minutes
= off
= on
= short
= medium
= long
= extra long
= 3 seconds
= 6 seconds
= 10 seconds
= no
= yes
4.
To save the changes, press and hold
four seconds.
Note: Following a power failure, the factory basic set-
tings are restored.
21.3 Discarding changes to the basic
settings
▶
Turn the function selector.
a All changes are discarded and not saved.
Childproof lock en
goes out in the display.
1
1
1
1
1
for approx.
23