VINCENT SV-237MKII Instructions For Use Manual page 43

CONNECTION OF THE LOUDSPEAKERS
If you are using ready made loudspeaker cables with 4 mm banana plugs, all you need to do is connect
the two plugs on each loudspeaker cable end to the two associated speaker connectors. Turn the connector
screws clockwise to fasten them.
If you want to use speaker cables equipped with spade lug connectors, every connector screw must be
opened by turning counter clockwise. After that, the lug must be moved under the screw head. Then, turn
the screw clockwise to fasten the lug to the connector. To avoid damages to the amplifier, make sure the
connection is tight and no bare metal from the cable lug connector makes contact with the rear panel or
with another terminal.
If no connector is to be used, remove approximately 1 cm length of insulation from each end of the speaker
wire. Twist the braid in order to avoid short circuits. Turn the fastener on the loudspeaker terminal counter
clockwise to loosen it and introduce the bare wire end into the exposed connector hole. Then turn the
fastener clockwise so that the wire is firmly clamped. Make sure the connection is pretty tight.
If you intend to connect two pairs of speakers, all loudspeakers must have a nomi-
nal impedance of at least 8 Ohm. If only one pair of speakers is connected, all types of
loudspeakers with a minimal nominal impedance of 4 Ohm can be used. Consider correct
polarity, the positive contact is mostly marked red or with "+". The side of the speaker
cable that has to be connected with the positive socket has a marking.
43