VINCENT SV-237MKII Instructions For Use Manual page 31

1
11 6
1. TREBLE
This is the knob for setting the treble proportions
(high frequencies) of the sound.
2. BASS
This is the knob for setting the bass proportions
(low frequencies) of the sound.
3. Display window for the tube
4. INPUT: Input Selector
This selector allows you to choose one of the six
inputs.
5. VOLUME: Volume control
This is the knob for the adjustment of the main
volume level of the system.
6. TONE: tone control
If deactivated, audio signals bypass the tone con-
trol that has been set with the dials BASS (2) and
TREBLE (1).
7. Input selection LEDs
The LED that is actually lit shows you what input
channel has been selected. Additionally these
LEDs show that the appliance is switched on and
not muted.
FRONT VIEW
2 3
9 7
4
8. Infrared remote control receiver
9. POWER
This is the main power switch for turning on and
off the device. The amplifier is separated from the
mains voltage when switched off and cannot be
set into a standby state.
10. LOUD: Loudness function
This button activates and deactivates an audio
signal correction that adapts the loudspeaker
audio signal to the human auditory sensation in
11. PHONES
If desired, you can connect a set of headpho-
nes with an impedance between 32 Ohm and
600 Ohm to this stereo jack. As long as the head-
phones are plugged in, the loudspeakers are swit-
ched off. The volume of the headphone can be
changed with the rotary knob "VOLUME" (5)(25).
Before plugging-in a headphone, the volume set-
ting should be reduced.
5
10 8
31