Table of Contents
Advertisement
General Operating Instructions
In addition to these operating instructions, you must also
observe and follow the operating instructions that are detailed
in the Blower System operator's manual that was included
with the blower mount of this machine.
Before Operation
Clear the lawn of all sticks, stones, wire and other debris
which may be caught or thrown by the mower blades.
Check grass condition. If wet, wait until later in the day. If
grass is wet, the grass catcher is likely to become plugged.
For efficient bagging, air circulation under the mower
deck, through the discharge chute and into the bag is
very important.
For this reason, BEFORE YOU BEGIN MOWING you should
make certain the underside of the mower and the underside
of the catcher lid are free from grass and debris.
Make sure that there is a snug fit between mower deck,
blower housing (or discharge boot), discharge tube, and
grass catcher cover.
Mowing with the Collection System
Always operate with throttle at full speed when mowing.
Grass should be cut often, and not too short. If grass is too
long or lush it may be necessary to keep ground speed to a
minimum or to cut only half the width of the mower to prevent
clogging. If grass is long, operate with mower in high cutting
postion for first pass, cutting again in a lower position on a
second pass.
Do not open the cover with mower engaged.
If a large amount of cut grass is spilling out from under deck,
the discharge hose may be plugged or the grass catcher
may be full -- Disengage the blower (blades) and remove
the ignition key, wait for all parts to stop and then empty the
catcher or clear the discharge tube.
20
WARNING
Disengage the blower (blades) and remove the ignition key,
wait for all parts to stop before disconnection or unlatching
any parts attached to blower or collection system.
To reduce fire hazard, keep the engine, rider and mower
free of grass, leaves and excess grease. Do not stop or
park rider over dry leaves, grass or combustible materials.
CAUTION
Always wear hearing protection when operating.
Note: Be careful when turning away from objects. The
collection system may collide with objects causing damage.
After Operation
For the blower:
1. The blower housing and discharge tube should be
removed for cleaning.
For the collection system:
1. Remove any accumulated debris from the inside of the
collection unit.
2. Remove any debris from the screen on the underside of
the lid, if equipped.
Note: The lid screen can be partially removed for easier
cleaning and should be cleaned regularly.
3. Make sure that there is a snug fit between mower deck,
blower housing, discharge tube, and grass catcher cover.
Mowing Without the Collection System
To remove the blower, see the instructions in Collector
System Removal . All of the instruction must be followed in
Collector System Removal to remove the collector, blower,
collector hose, and front weights, and the discharge chute
properly installed and adjusted in the down position.
ferrismowers.com | snapper.com
Advertisement
Table of Contents
